Metra Electronics DAT Combo Manuel d'utilisateur télécharger pdf (Page 2)

GMOS-LAN-09

From the 16-pin harness with stripped leads to the aftermarket radio:

• Connectthe(2)Redwirestotheaccessorywire.

 Note: If installing the ASWC-1, there will be an accessory wire in the

12-pin harness to connect as well.

• ConnecttheOrange/White wiretotheilluminationwire.Iftheaftermarket

radiohasnoilluminationwire,tapeofftheOrange/Whitewire.

• ConnecttheWhite wiretotheleftfrontpositivespeakeroutput.

• ConnecttheWhite/Blackwiretotheleftfrontnegativespeakeroutput.

• Connectthe Gray wiretotherightfrontpositivespeakeroutput.

• ConnecttheGray/Blackwiretotherightfrontnegativespeakeroutput.

• ConnecttheBlue/White wiretotheampturn-onwire.

Note: This wire must be connected to turn the interface on.

• ConnecttheBrown wiretothemutewire.Iftheaftermarketradiodoesnot

haveaMutewire,tapeupthe Brown wire.Ifthe Brownwireisnotconnected,

theradiowillturnoffwhenOnStarisactivated.

Thefollowingwiresarefortheaftermarketradiosthathavenavigationbuiltin:

• ConnecttheLight Greenwiretotheparkingbrakewire(ifapplicable).

• ConnecttheBlue/Pinkwiretothespeedsensewire(ifapplicable).

• Connectthe Green/Purplewiretothereversewire(ifapplicable).

From the GMOS-LAN-09 harness:

(a) 16-pin harness to the aftermarket radio:

• ConnecttheYellowwiretothe12-voltbatterywire.

• ConnecttheBlack wiretothegroundwire.

• ConnecttheGreenwiretotheleftrearpositivespeakeroutput.

• ConnecttheGreen/Blackwiretotheleftrearnegativespeakeroutput.

• ConnectthePurplewiretotherightrearpositivespeakeroutput.

• ConnectthePurple/Blackwiretotherightrearnegativespeakeroutput.

(b) 22-pin harness to the aftermarket radio:

• TheBlack/YellowwireisfortheOnStarvolumeadjustment.Thiswillbe

discussedintheOnStarLevelAdjustmentsectionofthisinstruction.

• TheDINconnectorisforusewiththeoptionalAX-LCD(soldseparately).This

willgiveyoutheoptionofchangingthesettingsinyourpersonalizationmenu.

• ConnecttheWhiteRCAtotheaftermarketradio’sleftAudioAUXin.

• ConnecttheRedRCAtotheaftermarketradio’srightAudioAUXin.

Note: To retain the factory 3.5mm jack, the radio must have an Audio AUX in.

Connections to be made

1 2 3 4

Pas de commentaire

Metra Electronics DAT Combo Manuel d'utilisateur Page 2